How to backwash an index pool pump?

When your pool pump isn’t working, the first thing you need to do is isolate the problem. The most likely cause of a pump that won’t start is a blocked filter. If that’s the case, replace it. If the problem is somewhere else, you’ll need to determine the source of the problem. In most cases, the source is a debris jam somewhere in the system. If you see something floating in the pool, you need to know how

How to backwash an index pool pump reservoir?

Before you start the backwash, you’ll need to find the outlet on your pump’s reservoir. There’s usually a thin plastic hose that connects to it. Remove the hose and fill the reservoir with water, keeping in mind that the water level should be at least half an inch above the intake pipe. Turn on your pump and set the flow rate to its lowest setting. Now, slowly pour the water back into the reservoir. Don’t overfill it or

How to backwash an index pool pump cover?

If your pool pump has a cover, you can also backwash it. First, prop up the cover to ensure it’s off the pump (or, at least, off enough that you can see the pump). Remove the cover, then use your hose and fill the pump with water. Turn the pump on and let the water flow through the cover for a few minutes. Then, turn the pump off. Now, use your hose to drain the water that collected in the pump.

How to backwash an index pool pump motor?

For this step, you will need to loosen or remove the cover over the impeller. Once you have done this, you will need to drain the water out of the pump. Use a hose attached to your vacuum to slowly pull the water out. After you have removed as much of the water as possible, turn the pump on. Then slowly spin the impeller by hand. If it is spinning freely, you have successfully backwashed your pump! If it is still not moving freely, check your wiring

How to backwash an index pool pump filter?

Now, the next step is to backwash the filter. Fortunately, you can do this either by using the hose method or by using the basket method. To do this, simply turn on the filter pump and slowly run water down the filter. When you have finished, turn the pump off and leave the filter on for an additional 15 minutes to allow the filter to drain completely.