How to clean faucet water filter?

Faucet water filter is very important for our health since the water that goes through it is free from impurities and bacteria. Thus you need to clean the water filter every month or once in a month, so as to have clean water that is safe to drink. There are a few ways to clean water filters but most of them are quite complicated and require proper care. When it comes to the best way to clean faucet water filter, the idea behind it is to clean the water filter

How to clean water filter on a faucet?

First, turn off the faucet. Afterward, remove the faucet water filter by turning it counterclockwise. Next, use a rag and scrub the filter using circular motions. Do not use any cleaning agents or any other products on the filter. Use only warm water to clean the filter. It’s important to dry the filter after cleaning. Drying the filter is very important to avoid clogging it.

How to clean water filter faucet?

After a while, the filter can get dirty, and you may need to clean it. The easiest way to clean the water filter is by using water. Turn off the water supply, and hold the faucet with the filter under the water stream. After you fill the water to the top, let the water flow over the filter for a few minutes. Then, slowly turn the water off. You may want to use a gentle scrub brush to clean the filter. Now, turn the water back

How to clean water filter for faucets?

First, turn off the water supply. You can do this either by pressing the cut-off button at the water meter or by turning off the main water switch. If you are not sure where these are, consult your handyman. Now, loosen the faucet’s cartridge (the small plastic piece that holds the filter in place), and remove the filter. Now, pour in a sink full of warm water and submerge the filter in it. Leave it in for a few minutes

How to clean faucet filter cartridge?

To clean the cartridge, first, remove it from the faucet. Then, use a wet sponge and dip it in vinegar, water, baking soda or a mixture of vinegar and baking soda. Keep the cartridge wet for about 10 seconds, then replace it. If you want to test it, turn on the faucet and let the water run for a few seconds. If it is water-free, your filter is clean. If not continue cleaning it.