How to drain an above ground pool using the pool pump?

The first thing you need to do is turn off your pool pump and open all the drain valves that are closest to the pool’s skimmer and water return. The easiest way to do this is by using an adjustable wrench or pliers to loosen the hose faucets and slowly release the water. When all of the valves are opened, let the water drain completely. You should have a pool with less than a one inch of water in it. Once the water is drained, you can

How to drain an above ground pool with a pool pump manual

If you do not have a power outlet near your pool, or if the pump is broken, you may be able to use a manual pool pump. Using this method, you can pull the water out of your pool with a hand pump, usually by using a bucket. You can either use hand tools or a power auger to push the water towards the pool's drain. The downside with this method is that it can be very strenuous, especially when the water is deep.

How to drain an above ground pool without a pool pump?

If you are looking to drain an above ground pool without a pool pump, the most common method is to use a drain tube and a bucket. A drain tube is a small plastic pipe, usually a few inches long, with a small hole in the end. Similar to a sink drain, it is attached to a drain valve in the pool. Once the hole is cut in the end of the tube, you will need to connect it to a bucket or a hose. The bucket or hose should be

How to drain an above ground pool without a pool pump manual?

This method is the easiest because you do not need to learn how to use the pool pump. You just need to disconnect the pool hose from the pool pump and drain the water out of the pool. You can do this by reaching up and holding onto the edge of the pool with one hand and the hose with the other hand. Turn on the hose to slowly push the water down into the drain. This can be very slow but if you push too hard you will just end up pushing water back into

How to drain an above ground pool with a pool pump?

The most common way to drain an above ground pool is to use a pool pump. When you turn on the pump, it pulls water from the pool and into the pool pump’s intake pipe. The water flows through the motor, which drives the impeller (spiral-shaped piece that throws the water out of the pump’s outlet pipe). The water is then pushed through the filter system and into the pool. The water is drained out of the pool and back into the ground