How to install victor mousetrap?

You can install the mousetrap in any room of your home, however, it is important to place the installation in an easily accessible location. In addition, it is best to install it near the entry gate of your home, or the place where most of your visitors will enter. You need to be able to check if someone has tampered with the mousetrap before you enter your home.

How to install mousetrap on deck?

The installation of mousetrap on deck is very easy. First, cut two strips of deck board that are long enough to span the length of the board and the width of the mousetrap. The strips should be at least 6 inches long to allow for a good connection. Fasten the two strips together with deck screws. If you have a power drill, you can also use deck screws. Use the two strips to hold down the board and secure it to the wall. Then,

How to set up victor mousetrap?

Connect the 5V power supply to the green wire, the red wire to the ground, and the yellow wire to the white wire. If you get a flashing red light, your wiring is fine. If the light is flashing slowly or constantly, the wiring is not good. Try re-soldering the connections or take it to a repair shop.

How to install a victor mousetrap on deck?

The next step is to attach all four corners of the deck to the floor using the 3/4" carriage bolts. Screw the carriage bolts in tightly. The nuts on the bolts will create pressure on the fastener threads, locking it in place. Leave the deck alone for about 24 hours before placing your mouse traps on it. Soak the traps in water for about 30 minutes so they’re moist. If you like, add a few drops of food coloring to the traps before placing them on