How to use sea foam spray on motorcycle?

Using sea foam is one of the easiest ways to clean your bike. Unfortunately, there are many misconceptions about what you can and cannot do when it comes to using sea foam. We have a few tips that will keep you from making the wrong choice.

How to use water foam spray on dirt bike?

Water foam is a very common product used for cleaning all kinds of surfaces. Its main purpose is to clean dirt and grease from your bike’s surfaces, without damaging the paint or leaving any residue. Most bike riders know how much damage water alone can do when it comes to bike cleaning. The idea of using this product rather than water alone is to promote better cleaning and a more gentle surface. The water foam creates a lighter surface tension, which allows the dirt to be cleaned off rather than sitting

How to use water foam spray on motorcycle?

Apply a small amount of water foam on your motorcycle’s grime-prone areas. Let the foam sit for a few minutes, then gently scrub off using a towel or brush. Do not scrub too hard. This will remove the dirt, but it will also remove the protective wax coating the bike’s surface. Do not use water alone or use detergent. Doing so might ruin your bike’s paint.

How to use Sea foam spray on motorcycle?

For the best results, use a foam motorcycle helmet. While it may seem as if the foam is designed to make riding more comfortable, it actually works to help repel water. The particles of the foam have millions of microscopic pores that allow water to pass through it. This allows the water to quickly evaporate off your bike and hair, helping to keep you cool and dry. The chemicals found in most motorcycle foam also have anti-bacterial properties that can help to keep you clean and cut down

How to use Sea foam spray on dirt bike?

A dirt bike can be a perfect off-road vehicle, but you need the right fuel and lubrication to make sure it runs smoothly. Also, to keep your bike clean, you can use a motorcycle foam, which not only cleans and protects the bike but also acts as an anti-corrosion agent. You can easily apply the foam to the bike using a foam gun or a bucket. If you do not have a foam gun, you can also use an old toothbrush or simply use